Filter
Top Products
126 Installing System Components
Installing the System Fan
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the system and protecting against electrostatic
discharge.
1
Hold the replacement fan with the fan cable on the left side (opposite of
the power supply), and align the edges of the fan with the securing slots.
2
Slide the fan left into the securing slots until the fan release tab locks into
place. See Figure 3-32.
3
Connect the cable to the FAN_2 connector on the system board (see
Figure 6-1
for the connector location).
4
Install the processor shroud. See "Installing the Processor Shroud" on
page 74.
5
Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
6
Close the system. See "Closing the System" on page 70.
7
Place the system upright and on its feet on a flat, stable surface.
8
Reattach any peripherals, then connect the system to the electrical outlet.
9
Turn on the system and attached peripherals.