Filter
Top Products
34 About Your System
Error: Remote
Access
Controller
initialization
failure
The Remote Access
Controller failed to initialize.
Ensure that the Remote
Access Controller is properly
installed (see "Installing a
RAC Card" on page 119).
Error 8602 -
Auxiliary Device
Failure
Verify that mouse
and keyboard are
securely
attached to
correct
connectors.
The mouse cable connector
is loose or improperly
connected, or the mouse is
defective.
Check the connection from
mouse cable to the system. If
the problem persists, try
another mouse, or see
"Getting Help" on page 205.
Fatal Error
caused a system
reset:
Please check the
system event log
for details
A fatal system error occurred
and caused the system to
restart.
Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in "Troubleshooting
Your System" on page 159 for
any faulty components
specified in the SEL.
Gate A20 failure Faulty keyboard controller;
faulty system board.
See "Getting Help" on
page 205.
General failure The operating system is
unable to carry out the
command.
This message is usually
followed by specific
information. Note the
information, and take the
appropriate action to resolve
the problem.
Keyboard
Controller
failure
Faulty keyboard controller;
faulty system board.
See "Getting Help" on
page 205.
Table 1-6. System Messages (continued)
Message Causes Corrective Actions