Filter
Top Products
92 Installing System Components
Removing the Diskette Drive
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the system and protecting against electrostatic
discharge.
1
Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2
Open the system. See "Opening the System" on page 68.
3
Remove the front drive bezel. See
"Removing the Front Drive Bezel
" on
page 66.
4
Disconnect the power and data cables from the diskette drive.
5
Slide the drive release latch in the direction of the arrow. See Figure 3-15.
6
Hold the latch in position and slowly pull the drive out of the bay.