Filter
Top Products
146 Installing System Components
Figure 3-40. Removing and Installing the Power Supply Distribution Board
9
If you intend to replace the redundant power supplies with a non-
redundant power supply, install the power supply cage cover on the power
supply cage.
a
Press the power supply cage cover into the power supply cage until the
the blue release pins lock into the release pin alignment holes. See
Figure 3-41.
To remove the power supply cage cover, pull the blue release pins until
the cover is free from the alignment holes, and lift the cover out of the
chassis.
1 release pin 2 securing slots (4)
3 power supply distribution board 4 securing tabs (4)
5 power supply cage
1
3
4
5
2