Filter
Top Products
142 Installing System Components
Figure 3-37. Removing and Installing the Chassis Intrusion Switch
Installing the Chassis Intrusion Switch
1
Align the chassis intrusion switch with the securing bracket notch. See
Figure 3-37.
2
Slide the switch into the securing bracket notch.
3
Connect the switch cable to the INTRUSION connector on the system
board. See
Figure 6-1
for the connector location.
4
Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
5
Close the system. See "Closing the System" on page 70.
6
Place the system upright and on its feet on a flat, stable surface.
1 securing bracket notch 2 chassis intrusion switch
3 INTRUSION connector on system
board
2
1
3