Filter
Top Products
28 About Your System
E1A15 SAS Cable D SAS cable D is missing or
bad.
Reseat the cable. If the
problem persists, replace
cable.
If the problem persists,
see "Getting Help" on
page 205.
E1A18 PDB Ctrl
Cable
Control cable for the power
distribution board (PDB) is
missing or bad.
Reseat the cable. If the
problem persists, replace
cable.
If the problem persists,
see "Getting Help" on
page 205.
E1A19 12V Cable
Fault
Power cable for the PDB or
cabled power supply is
missing or bad. They system
will not turn on.
Reseat the cable. If the
problem persists, replace
cable.
If the problem persists,
see "Getting Help" on
page 205.
E1B01 USB#
Overcurrent
Device plugged in the
specified USB port caused
an overcurrent condition.
Reseat the device cable. If
the problem persists,
replace or remove the
device.
E2010 No Memory No memory is installed in
the system.
Install memory (see
"Installing Memory
Modules" on page 130).
E2011 Mem Config
Err
Memory detected, but is not
configurable. Error detected
during memory
configuration.
See "Troubleshooting
System Memory" on
page 174.
E2012 Unusable
Memory
Memory is configured, but
not usable. Memory
subsystem failure.
See "Troubleshooting
System Memory" on
page 174.
Table 1-5. LCD Status Messages (continued)
Code Text Causes Corrective Actions