Filter
Top Products
Installing System Components 95
Figure 3-16. Installing Diskette Drive Shoulder Screws
10
From the front of the chassis, slide the drive into the drive bay until the
shoulder screws fit into their slots and snap securely into the sliding plate.
11
Connect the power cable to the drive.
12
Connect the data cable from the drive to the diskette drive connector
(FLOPPY) on the system board. See Figure 6-1 for the connector location.
13
Route the diskette drive data cable through the ribbon cable notch and
ribbon cable guides in the processor shroud as shown in Figure 3-17.
1 screws (4)
1