Filter
Top Products
94 Installing System Components
9
Close the system. See "Closing the System" on page 70.
10
Place the system upright and on its feet on a flat, stable surface.
11
Reattach any peripherals, then connect the system to the electrical outlet.
12
Turn on the system and attached peripherals.
Installing a Diskette Drive
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the system and protecting against electrostatic
discharge.
1
Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and attached peripherals.
2
Open the system. See "Opening the System" on page 68.
3
Remove the expansion card shroud. See "Removing the Expansion Card
Shroud" on page 72.
4
Unpack the replacement diskette drive, and prepare it for installation.
5
Check the documentation for the drive to verify that it is configured for
your system.
6
Remove the front drive bezel. See
"Removing the Front Drive Bezel
" on
page 66.
7
Remove the 3.5-inch insert on the front drive bezel. See
"Removing an
Insert on the Front Drive Bezel
" on page 67.
8
Remove the four shoulder screws from the back of the insert; the 3.5-inch
insert holds four screws.
9
Attach the four screws to the diskette drive as shown in Figure 3-16.