Filter
Top Products
90 Installing System Components
3
If you are replacing a hot-plug hard drive, remove the drive that you are
replacing. See "Removing a Hot-plug Hard Drive" on page 88.
If a replacement hard drive does not have the lever-release hard drive
bracket attached, remove the bracket from the old drive and install it on
the new drive. See Figure 3-14.
The SAS/SATA hard-drive bracket has mounting holes to enable either a
"SAS" or "SATA" mounting position, depending on your hard drive type.
See Figure 3-14.
Figure 3-14. Removing and Installing a Lever-release Hard Drive Bracket
4
Install the hot-plug hard drive.
a
Open the handle on the hard-drive carrier.
b
Insert the hard-drive carrier into the drive bay until the carrier
contacts the backplane.
c
Close the handle to lock the drive in place.
1 mounting holes 2 screws (4)
3 drive bracket 4 hard drive
2 3
4
1