Filter
Top Products
Installing System Components 83
Figure 3-9. Removing and Installing a Hard Drive
NOTE: If you do not intend to replace the drive, it is recommended that you remove
the drive from the guide bracket (see Figure 3-10) and insert the empty guide
bracket back into the drive bay. This eliminates the likelihood that the empty bracket
will be misplaced or improperly stored while not in use.
5
Close the system. See "Closing the System" on page 70.
6
Place the system upright and on its feet on a flat, stable surface.
7
Reattach any peripherals, then connect the system to the electrical outlet.
8
Turn on the system and attached peripherals.
1 hard drive 2 data cable
3 power cable 4 carrier release tab (2)
3
4
2
1