Filter
Top Products
Installing System Components 147
b
Install a non-redundant power supply. See "Installing a Non-redundant
Power Supply" on page 81.
Figure 3-41. Removing and Installing the Power Supply Cage Cover
Installing the Power Supply Distribution Board
1
If present, remove the power supply cage cover.
Pull the blue release pins until the cover is free from the alignment holes,
and lift the cover out of the chassis. See Figure 3-41.
2
Position the power supply distribution board so that the securing tabs on
the chassis are fully inserted into the securing slots on the board. See
Figure 3-40.
1 power supply cage cover 2 release pins (2)
3 release pin alignment holes (2) 4 power supply cage
1
3
2
4