Filter
Top Products
Installing System Components 155
NOTICE: To prevent damaging the processor, do not pry the heat sink off of the
processor.
12
Remove the processor(s). See "Removing a Processor" on page 133.
13
If applicable, remove the SAS/SATA backplane. See "Removing the
SAS/SATA Backplane" on page 148.
14
Carefully route any loose cables away from the edges of the system board.
15
Remove the system board from the chassis. See Figure 3-44.
a
Pull and hold the blue system board release pin.
b
While holding the release pin and the system board touch point, slide
the system board towards the front of the system, and lift the board
out of the chassis.
Figure 3-44. Removing and Installing the System Board
1 system board release pin 2 system board
3 system board touch point 4 system board securing slots
1
2
3
4