Filter
Top Products
Installing System Components 141
Chassis Intrusion Switch
Removing the Chassis Intrusion Switch
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the system and protecting against electrostatic
discharge.
1
Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2
Open the system. See "Opening the System" on page 68.
3
Remove the expansion card shroud. See "Removing the Expansion Card
Shroud" on page 72.
4
Disconnect the chassis intrusion switch cable from the INTRUSION
connector on the system board. See Figure 3-37.
5
Slide the chassis intrusion switch out of the securing bracket notch. See
Figure 3-37.
6
Remove the switch and its attached cable from the system.