Filter
Top Products
DISASSEMBLY AND ASSEMBLY
Rev. B
3-5
5
3.2.6.21 CR (Carriage Encoder) Sensor Removal
Step 1: Remove the printhead. (Refer to Section 3.2.2.)
Step 2: Disconnect the red 4-pin CR sensor connector from the carriage connector junction board.
Step 3: Remove the two CP(S-P1) (M2.6 x 5) screws securing the CR sensor to the carriage and remove
the sensor.
Carriage
4-pin C onnector
C arriage Encoder Sensor
C arriage C onnector
Junction Board
Figure 3-78. CR Sensor Removal 1/2
Carriage
C arriage Encoder
Sensor
C P (S -P 1 )(M 2 .6 X 5 )
Figure 3-79. CR Sensor Removal 2/2