Filter
Top Products
DFX-8500
Rev. B
3-5
6
3.2.6.22 Carriage Mechanism Disassembly
This section describes how to disassemble the carriage mechanism, including removing the carriage, CR
timing belt, and front and rear carriage guide shafts.
Step 1: Remove the CR motor. (Refer to Section 3.2.6.20.)
Step 2: Remove the belt pulley from the belt pulley holder.
Side Fram e (L)
Belt Pulley
Belt Pulley
H older
Figure 3-80. Belt Pulley Removal
Step 3: Unhook the spring securing the encoder belt to the right side frame. (Refer to Figure 2-5.)
Step 4: Loosen the two flange nuts securing the front carriage guide shaft to the left and right side frames.
Flange N ut
Flange N ut
Front C arriage G uide Shaft
Figure 3-81. Front Carriage Guide Shaft Removal