Filter
Top Products
GENERAL DESCRIPTION
Rev. B
1-
11
Overlapping multi-part forms : Refer to Figure 1-6.
LM
Perforations
C a rrie r
PW
PL
NA
OL
BM
TM
RM
Continuous Paper
PW (width) Refer to Section 1.2.12.
PL (length) Refer to Section 1.2.12.
LM (left margin) 19 mm to 31mm
RM (right margin) 19 mm or more
TM (top margin) 21.2 mm or more
BM (bottom margin) 4.2 mm or more
OL (overlapping length) Less than 13.3 mm
NA (non printable area) 25.4 mm or more
Notes 1:
Feeding backward or paper (PATH) selection are prohibited.
Notes 2: If In the top 75 mm area, the paper feeding pitch may be irregular.
Notes 3: If the optional pull tractor is used, the top 120 mm area should not be printed..
Notes 4: Forms-override printing is available 20 lines after the paper end.
(Paper feeding pitch is not guaranteed.)
The end of the printable area is 9 to 15 mm apart from the bottom edge of the paper.
Figure 1-6. Overlapping Multi-part Form Printable Area