Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
99
Resolving the Temperature Timeout Error Message
Step Procedure
1 Run a self-test from the Printer
a. Select Menu from the LCD.
b. Select Print Test Image from the menu.
c. Select Gray/Align Self test from the Menu.
If no error occurs, the Transfer Temperature settings in Driver may be too high or
too low. See the Adjusting the Image Transfer tab
procedure in Section 3, page
204, for instructions on how to adjust the transfer settings.
2 Resolve the Transfer Roller not being able to reach the optimum temperature.
a. Turn the Printer OFF and ON to reset and try reprinting.
b. If the problem persists, see the Resolving the Transfer Cooling error
procedure in Section 2, page 97, to test the Thermocouple.
Resolving the Transfer Lift Error Message
Symptom: The Printer cannot determine the placement of the Lamination Roller.
Step Procedure
1 Check to ensure that the Transfer Lift Motor (840130) is running.
a. Disconnect the motor from the Lamination Board.
b. Connect a 9-VDC battery to the motor’s leads.
c. Replace the Transfer Lift Sensor if the motor does turn. See the Replacing
the Transfer Lift Sensor procedure in Section 5, page 336.
d. Replace the Transfer Lift Motor if the motor does not turn. See the Replacing
the Transfer Lift Motor procedure in Section 5, page 337.