Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
37
Printer Components: Lamination Roller
Danger: The Printer’s Lamination Roller can reach temperatures exceeding 350
degree F (175 C). Use extreme caution when operating the Laminator. Never touch the
Lamination Roller unless the Printer Power has been turned off for at least 20 to 30 minutes.
Type Description
Controls Both the Printer itself and the Printer’s software Driver control the built-in
laminator.
Temperature
Adjustment
To change the temperature of the laminator, adjust its temperature
through the Lamination tab within the Printer Driver setup window.
Once adjusted, the new temperature settings will be sent down with the
next print job along with the rest of the Printer Driver information.
New
Temperature
Setting
Before printing begins, the laminator will automatically adjust itself to the
new temperature setting. (Note: This new temperature setting will
remain programmed within the Printer until it is once again changed
within the Printer Driver or until the Printer is turned OFF.)
Whenever the Printer is turned OFF, the laminator will automatically reset
itself and return to its default temperature the next time the Printer is
turned ON.
• Flip the Power Switch to OFF.
OR
• Disconnect the Printer's power cord.
(Technician Note: Both the Power Switch and the Printer’s power cord
serve to reset the laminator to its default temperature. The temperature
setting within the Printer Driver, however, will stay the same until it is
changed.)