Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
58
Reviewing SmartGuard™ Error and Status Messages
Message Cause Solution
Access Card
Deleted
The data on the SmartGuard Access
Card was successfully deleted.
Press the OK button to continue.
Access Card
Ready
The SmartGuard data has successfully
been encoded onto the SmartGuard
Access Card.
Press the OK button to continue.
Delete Card
Data?
To delete the SmartGuard Access
Card data, press the Yes button.
To cancel the deletion process,
press the NO button.
Insert Access
Card
You are trying to print without the
SmartGuard Access Card inserted.
Insert a valid SmartGuard
Access Card.
Insert New
Card
To duplicate the SmartGuard Access
Card, remove the valid access card
and insert a blank access card.
Press the Copy button to
complete duplication or press
Cancel to cancel duplication.
Invalid Access
Card
The SmartGuard Access Card is
invalid or is inserted backwards or up
side down.
Insert a valid SmartGuard card
or reinsert the card properly with
the chip end down and facing
you.
Invalid
Password
You have entered an invalid
SmartGuard password.
Re-enter the correct password
using any of the standard
keyBoard characters.
Reading
Access Card
Indicates the Printer is reading the data
from the SmartGuard Access Card.
Press the OK button to continue.
Continued on the next page