Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
100
Resolving the Output Stacker errors
Symptom: The Cards feed into the Output Stacker, but they are not lifted up into place.
Step Procedure
1 Check operation with these steps.
a. Reset the power on the Printer.
b. Visually confirm that the stacker cycles on power-up.
2 Verify that the wires (840121 and 840115) from the Output Stacker are
connected properly and are well seated in the wire harness.
3 Ensure that the Output Stacker is set to the correct card size.
a. Slide the wall of the Output Stacker to the correct card size.
4 Test the operation of the Stacker Lift Motor.
a. Disconnect the cable connector.
b. Connect a 9-Volt battery to the wires.
c. Replace the motor if it does not turn.
d. Replace the Lam Board as needed if the motor does turn. See the
Replacing the Lamination Board (140402)
procedure in Section 5, page
368.