Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
102
Resolving the Overlaminate Jam (continued)
Step Procedure
4 a. Once the jam is cleared, replace the media and close the Lamination
Module.
b. Press the Lamination Module's Resume button to retry Lamination
(depending on the error and how far you moved the card or overlaminate,
this may not be possible).
c. Press the Lamination Module's Cancel button to reset the Lamination
Module for the next card. (Note: The Lamination Module buttons only
affect the card in the Lamination section.)
The Printer's LCD softkey buttons affect any card in either the Print Station or
the Lamination Station (e.g., the Lamination Module's Cancel button cancels
only the Lamination job; the Printer's CANCEL softkey button cancels both the
print and Lamination jobs).
• If both the Print Station and Lamination Station are open, the LCD's
FORWARD and BACK softkey buttons will move all rollers.
• If only the Lamination Module is opened, only the Lamination Module
buttons will move the Lamination rollers.