Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
4
Adjusting for the Resin Dither _________________________________________ 191
Using the Print Both Sides option ______________________________________ 192
Using the Split 1 Set of Ribbon Panels option_____________________________ 193
Using the Print Back Side First option___________________________________ 194
Using the Print on Back Side Only option________________________________ 195
Using the Rotate Front 180 Degrees or Rotate Back 180 Degrees options _______ 196
Using the Print in Single Card Mode option ______________________________ 197
Using the Link Card to Print Job option _________________________________ 198
Using the Disable Printing option ______________________________________ 199
Using the Image color tab ______________________________________________ 200
Using the Image Transfer tab____________________________________________ 204
Adjusting the Image Position controls ___________________________________ 205
Adjusting the Transfer Dwell Time and Temperature _______________________ 207
Adjusting the Flattener Temperature ____________________________________ 208
Using the K Panel Resin tab_____________________________________________ 209
Selecting the Full Card with the K Panel Resin tab_________________________ 210
Selecting the Defined Area(s) with the K Panel Resin tab ___________________ 211
Selecting the Undefined Area(s) with the K Panel Resin tab _________________ 212
Defining the Area to activate the Card Grid ______________________________ 213
Measuring the Total Card area_________________________________________ 214
Measuring the Area to be positioned on the Card __________________________ 215
Selecting the Print YMC under the K and Print K Only options_______________ 216
Using the Magnetic Encoding tab ________________________________________ 218
Using the Encoding Mode option ______________________________________ 219
Encoding the Mode/Coercivity/Magnetic Track Selection ___________________ 221
Reviewing the Magnetic Track Options _________________________________ 222
Reviewing the Enable MLE Support checkbox____________________________ 223
Reviewing the Verification options _____________________________________ 224
Reviewing the Shift Data Left _________________________________________ 225
Reviewing the ISO Track Locations ____________________________________ 226
Sending the Track Information ________________________________________ 227
Reviewing the Sample String__________________________________________ 228
Reviewing the ASCII Code and Character Table __________________________ 229
Using the Card tab ____________________________________________________ 230
Selecting the Card Size from CR-80, CR-90 or CR-100 _____________________ 231
Selecting the Custom Card Size________________________________________ 233
Selecting the Card Type______________________________________________ 234
Reviewing the Orientation ____________________________________________ 236
Specifying the Copies _______________________________________________ 236
Clicking on the About button__________________________________________ 237
Using the Lamination tab (only with Card Lamination Module) ________________ 238
Selecting the Lamination Position ______________________________________ 239
Selecting the Lamination Side _________________________________________ 240
Selecting the Lamination Type ________________________________________ 241
Adjusting the Transfer Dwell Time and Transfer Temperature________________ 242
Selecting the Sensors button and Defaults button __________________________ 242