Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
101
Card Lamination Errors
Resolving the Overlaminate Jam
Symptom: This section only applies if the Printer is equipped with an optional Card
Lamination Module. If the overlaminate becomes stuck to the card or jammed inside the
Printer, the LCD Display will indicate that it is jammed.
Step Procedure
1 Leave the power ON and open the Top Cover and Lamination Station.
2 Remove the Take-Up core (the side with used overlaminate on it) from in
between the two black Drive Hubs.
3 Steadily pull the overlaminate free from where it is jammed. If it is stuck to the
card, pull the overlaminate off the card.
• Jammed or Wrapped: If it is jammed or wrapped around the rollers, press
and hold down the Lamination Module's Resume button while gently
pulling on the overlaminate.
Caution: Do not jerk the overlaminate to free it, since this will
increase the chance of breaking it.
• Broken: If it does happen to break, remove and tape the broken end of
the supply roll directly onto the take-up roll. Then, wind a few inches worth
of overlaminate from the supply roll onto the take-up roll. (Note: Ensure
the overlaminate is passing beneath both the supply and take-up rolls.)
Continued on the next page