Filter
Top Products
180 MPCMM0001 Chassis Management Module Software Technical Product Specification
Remote Procedure Calls (RPC)
Note: Error codes 100 and 101 will never be returned by the CMM when using RPC. If you receive these
error codes, they are most likely being returned by the RPC client. Consult your RPC client
documentation or code to find the description of these errors.
100 E_SNMP_CMD_UNSUPPORTED Internal CMM Error.
101 E_SNMP_ERROR Internal CMM Error.
102 E_SNSR_VALUE_OUT_OF_RANGE Internal CMM Error.
103 E_SNSR_AUTH_ERROR Internal CMM Error.
104 E_WP_INITIALIZE_LIBS Internal CMM Error.
105 E_WP_CFG_READ_ERROR CMM config file may be corrupted.
106 E_WP_CFG_WRITE_ERROR CMM config file may be corrupted.
107
E_WP_THRESHOLD_UNSUPPORTED
The sensor being queried doesn't support a
particular threshold.
108
E_WP_INVALID_TARGET
The sensor doesn't support a "current”
value. This happens when querying a
current value on a discrete sensor type.
109 E_WP_INVALID_LOCATION Not a valid -l location.
110 E_WP_INVALID_DATA_ITEM Not a valid -d parameter.
111 E_WP_INVALID_SET_DATA Not a valid -v parameter.
112 E_WP_CMD_UNSUPPORTED Not a supported command.
113
E_WP_STANDBY_CMM
Can't execute this command on the
standby CMM.
114 E_WP_I2C_ERROR Internal CMM Error.
115 E_FT_SEM_GET_FAILURE Internal CMM Error.
116 E_DRONE_NOT_FOUND Internal CMM Error.
117 E_INTERNAL_ERROR Internal CMM Error.
118 E_BPM_PWR_SUPPLY_NOT_PRESENT Internal CMM Error
119 E_NEM_INTERNAL_FAILURE Internal CMM Error.
120 E_WP_CMM_RESET CMM Reset.
121 E_UPDATE_INPROGRESS Firmware update in progress.
122 E_CLI_INVALID_GET_DATA_ITEM Not a valid getdataitem.
123 E_CLI_INVALID_SET_DATA_ITEM Not a valid setdataitem.
124 E_SNSR_UPDATE_INPROGRESS Sensor update in progress.
125 E_WP_SNSR_EVN_DESCRIPTION_NOT_FOUND Sensor event description not found.
Table 80. Error and Return Codes for the RPC Interface (Sheet 4 of 4)
Code #: Error Code String Error Code Description