Filter
Top Products
58 MPCMM0001 Chassis Management Module Software Technical Product Specification
Process Monitoring and Integrity
6.9.2.10 Process Severity
An indicator for the importance of a given process. This severity will determine at what level SEL
entries are generated and when reboots should occur on an active CMM.
Values: 1 = minor, 2 = major, 3 = critical. Default: 1.
ProcessSeverity = 1
6.9.2.11 Recovery Action
This is the recovery action to take upon detection of a failed process.
Values: 1 = no Action, 2 = process restart, 3 = failover and process restart, 4 = failover and reboot.
Default: 1. (dynamic)
RecoveryAction = 1
6.9.2.12 Process Restart Escalation Action
This determines the action to take if the RecoveryAction includes "process restart" and it fails.
Values: 1= no action, 2 = failover and reboot. Default: 1. (dynamic)
ProcessRestartEscalationAction = 1
6.9.2.13 Process Restart Escalation Number
This is the number of process restarts that are allowed (within the interval specified below) before
escalation starts.
Values: 1 - 255. Default: 5.
ProcessRestartEscalationNumber = 5
6.9.2.14 Process Restart Escalation Interval
This is the interval in seconds at which the number of restarts will be limited (see above).
Values: 1 - 65535. Default: 900.
ProcessRestartEscalationInterval = 900
6.9.3 Process Definition Section of pms.ini
The following sections describe and give examples of each of the process types that are defined in
the pms.ini file.
6.9.3.1 Shadow Process
Shadow process must exist to monitor "Monitor Process". Therefore this process should never have
a recovery action of "no action".