Filter
Top Products
80 MPCMM0001 Chassis Management Module Software Technical Product Specification
The Command Line Interface (CLI)
8.4.5 Dataitem Parameter: -d
The dataitem is the parameter, identified by target and/or location, that the user is getting or setting.
The dataitem must be given for every CLI command.
8.4.5.1 Location Dataitem lists
Table 23 through Table 29 list the valid dataitems for each location when no target is specified.
Table 23. Dataitem Keywords for All Locations
Dataitem Description Get/Set CLI Get Output Valid Set Values
listdataItems
Used to find out what data
items are available on a target
or location.
Get
Listing of all valid data items that can
be issued for the specified location or
target
N/A
health
Retrieves the health
information about a particular
location or target.
Get
"Location/Target has no/minor/major/
critical problems"
N/A
Table 24. Dataitem Keywords for All Locations Except System
Dataitem Description Get/Set CLI Get Output Valid Set Values
listgetdataitems
Lists all available dataitems
that can be retrieved with
cmmget.
Get
Listing of all valid get data items that
can be issued for the specified
location or target
N/A
listsetdataitems
Lists all available dataitems
that can be set with cmmset.
Get
Listing of all valid set data items that
can be issued for the specified
location or target
N/A
healthevents
Retrieves events that
contribute to the health of the
location or target. This is a list
of events currently active on
the location or target. Health
events strings are documented
in Section 11, “Health Events”
on page 104
Get
List of currently active events. E.g.
"Major Event : +12V_B Lower critical
going low asserted
Major Event : +12V_A Lower critical
going low asserted"
N/A
listtargets
Used to find what sensors or
targets are available on the
location. This is the list of
sensors defined by the SDR
for that particular location.
Get
Listing of all the targets that are
available on the location
N/A