Filter
Top Products
MPCMM0001 Chassis Management Module Software Technical Product Specification 193
RMCP
20.7 IPMB Slave Addresses
In the current RMCP server implementation in the BMC, embedded ‘IPMI message’ within a
RMCP message is bundled with IPMB protocol. The ‘slave address’ required by this protocol
should be set to 20h to address the BMC. The RMCP client may use any of the address shown in
the range specified below as its slave Address. Only EVEN values are allowed. i.e., the least
significant bit of the slave address is always ‘0’.
20.8 CMM RMCP Configuration
To communicate with the CMM RMCP server a RMCP client must have the following
information:
• the RMCP server’s IP address
• the User Name, which is initially set to root
• the User Password, which is initially set to cmmrootpass
• and set the RMCP mode to “Full Access”
All of these were discussed in the CLI section above.
Table 88. RMCP Slave Addresses
Nodes Value
RMCP Server Slave Address 20h
RMCP Client Slave Address C0h-CEh