MPCMM0001 Chassis Management Module Software Technical Product Specification 257
Unrecognized Sensor Types
provides the text interpretation of the event. Its format is shown below:
\tSDRSensorName\tHealthEventString
Where:
• SDRSensorName is the name given to the sensor in the Sensor Data Record (SDR).
• HealthEventString is the CMM’s translation of the event.
28.3.2.3 SEL Raw Format
The final portion that SEL display might contain is the “raw” portion of the trap. This reports the
original sixteen bytes of the System Event as ASCII, upper case, hex bytes.
\tRaw Hex : [ 12 34 56 78 9A … (16 bytes hex) ]
Notice the square brackets have a space after the open bracket and before the close bracket. This is
intended to help parsing for any scripting languages.
At the end of the SEL display, there is always two trailing newlines.
28.3.3 Configuring SEL Format
When the command “cmmget [–l location] –d sel” used, a variable SELFormat in the cmm.cfg file
is used. This variable controls whether the “text” portion or the “raw” portion of the SEL display is
output along with the “header”. The header is always displayed.
28.3.3.1 SELFormat = 1 (text) Example Output
If the SELFormat variable is equal to 1 (text) the output is header plus text.
TimeStamp\n
\tSDRSensorName\tHealthEventString\n\n
28.3.3.2 SELFormat = 2 (raw) Example Output
If SELFormat is 2 (raw), the output is as below.
TimeStamp\n
\tRaw Hex : [ 12 34 56 78 9A … (16 bytes hex) ]\n\n
If SELFormat is 3 (text&raw), the example output is shown below:
28.3.3.3 SELFormat = 3 (raw&text) Example Output
TimeStamp\n
\tSDRSensorName\tHealthEventString\tRaw Hex : [ 12 34 56 78 9A … (16 bytes
hex) ]\n\n