Filter
Top Products
194 MPCMM0001 Chassis Management Module Software Technical Product Specification
RMCP
20.9 IPMI Commands Supported by CMM RMCP
The following IPMI commands are supported via RMCP by the CMM. To configure privileges for
the commands see Section 20.10, “Configuring IPMI Command Privileges” on page 196 below.
Table 89. IPMI Commands Supported by CMM RMCP (Sheet 1 of 3)
Command Type Defined In Command
IPMI Device Global IPMI 1.5 Spec
Get Device ID
Get Self Test Results
BMC Device and Messaging
Commands
IPMI 1.5 Spec
Set BMC Global Enables
Get BMC Global Enables
Clear Message Flags
Get Message Flags
Get Message
Send Message
Get Channel Authentication Capabilities
Get Session Challenge
Activate Session
Set Session Privilege Level
Close Session
Get Session Info
Get AuthCode
Set Channel Access
Get Channel Access
Get Channel Info
Set User Access
Get User Access
Set User Name
Get User Name
Set User Password
Chassis Device Commands IPMI 1.5 Spec
Get Chassis Capabilities
Get Chassis Status
Chassis Control
Get POH Counter
Event Commands IPMI 1.5 Spec
Get Event Receiver
Set Event Receiver