Intel MPCMM0001 Network Card User Manual


 
MPCMM0001 Chassis Management Module Software Technical Product Specification 81
The Command Line Interface (CLI)
Table 25. Dataitem Keywords for All Locations Except Chassis and System (Sheet 1 of 4)
Dataitem Description Get/Set CLI Get Output Valid Set Values
deviceid
Retrieves the device’s SDR
support, hardware revision,
firmware / software revision,
and sensor and event
interface command
specification revision
information. Implements Get
Device ID command. See
IPMI 1.5 Specification
Section 17.1.
Get
"GetDeviceID: < interpreted string
without label>
Device ID = <Device ID>
SDR Support = <device provides Device
SDRs>
Device Revision = <Device revision>
Device Available = <Device available:
0=normal operation, 1=device firmware>
Firmware Revision = <Firmware revision:
major.minor>
IPMI Version = <IPMI version>
Chassis Support = <Additional chassis
device support>
Bridge Support = <Additional bridge
support>
IPMB Event Generator Support =
<Additional IPMB Event Generator
support>
IPMB Event Receiver Support =
<Additional IPMB Event Receiver
support>
FRU Inventory Support = <Additional
FRU inventory device support>
SEL Support = <Additional SEL device
support>
SDR Repository Support = <Additional
SDR Repository device support>
Sensor Support = <Additional sensor
device support>
Manufacturer ID = <Manufacturer ID>
Product ID = <Product ID>
Aux Firmware Revision = <Auxiliary
firmware revision information>"
N/A
fruactivation
Set the activation state to
either activate or deactivate
the FRU. The Deactivate is
the same as a Graceful
Shutdown.
Set N/A
1=activate FRU
0=deactivate FRU
fruactivationpolicy
Get or Set the FRU
activation policy. A Get
returns whether the “Locked
Bit” is set. For example, if
blade 11 activation locked bit
is set, and if in M1, then
blade 11 cannot transition to
M2 until unlocked. If blade 11
activation locked bit is not set
then blade 11 can transition
from M1 to M2.
Both
"<location> activation locked bit is set. If
in M1, <location> cannot transition to M2
until unlocked"
OR
"<location> activation locked bit is not
set. <location> can transition from M1 to
M2"
1=set locked bit
0=clear locked bit