Intel MPCMM0001 Network Card User Manual


 
82 MPCMM0001 Chassis Management Module Software Technical Product Specification
The Command Line Interface (CLI)
frucontrol
Set the FRU payload to do
things like Cold Reset, Warm
Reset, etc.
The CMM location only
supports 2 (graceful reboot)
and will only work on standby
CMM. Using frucontrol on an
active or single CMM will
attempt a failover before
executing the command. If
failover is unsuccessful,
fruncontrol will not execute
and return an error.
Set N/A
0=cold reset
1=warm reset
2=graceful reboot
3=issue diagnostic
interrupt
hotswapstate
Retrieves the FRU’s current
M state (0-7).
Get "<location> Hot Swap state is M[x]" N/A
fruextractionnotify
Used to notify the Shelf
Manager that a FRU has
been extracted from the
shelf. Example is "cmmset -l
<location> -d
fruextractionnotify -v 1"
Set N/A 1=Extract FRU
ledproperties
Find out the number and
type of LEDs the FRU
supports and which LED it
can control. Implements the
Get FRU LED Properties
command. See PICMG 3.0
Section 3.2.5.6.
Get
Information pertaining to number and
control of the LEDs
"<location> has control of <main_leds>
<location> supports
<number_user_leds> user leds"
Where
<location> is the -l parameter (can be a
sub FRU)
<main_leds> is Comma-separated list of
<led> items
<led> is hsled, led1, led2, led3
<number_user_leds> is the decimal
number of user LEDs supported by FRU
N/A
picmgproperties
Query the maximum FRU
Device ID supported by the
IPMI controller. Implements
Get PICMG Properties
command. See PICMG 3.0
Table 3-9.
Get
"PICMG Properties: < interpreted string
without label>
PICMG Properties ID = <PICMG ID>
PICMG Extension Version = <PICMG
extension version=major.minor>
Max FRU Device ID = <Max FRU device
ID>
FRU Device ID = <FRU device ID for
IPMI controller>"
N/A
powerlevels
Returns the power levels
available for a FRU and the
number of watts drawn by
each.
Get
"ATCA FRU Power Levels:
Power Level 1 = A watts
...
Power Level n = B watts"
N/A
Table 25. Dataitem Keywords for All Locations Except Chassis and System (Sheet 2 of 4)
Dataitem Description Get/Set CLI Get Output Valid Set Values