Filter
Top Products
Troubleshooting
75
Change Setting
Tray #
/ Paper Size:
Paper Type:
The paper size and type set-
ting in the tray differs from that
of actual paper size and type in
the tray.
Load paper of the selected
size in the tray, and then
change the paper size setting
with the control panel. Or,
press {Form Feed}, and then
select the tray using the con-
trol panel. Or, press {Job Re-
set} to cancel the print job.
Close Front and/
or Right Cover
The front cover or right cover is
open.
Close the front cover or right
cover.
Close Upper Left
Cover
The upper left cover open. Close the upper left cover.
DHCP assigned
Cannot change
An attempt to change the IP
address, subnet mask or gate-
way address was made while
DHCP was set to [On].
Make the change after setting
DHCP to [Off].
Energy Save Mode In Energy Save Mode level 2. No action required.
Error: Enter 10
or 26 characters
An ID with an invalid number of
digits was entered for the WEP
key.
Enter the correct number of
digits for the WEP key.
Error: Enter 5
or 13 characters
An ID with an invalid number of
digits was entered for the WEP
key.
Enter the correct number of
digits for the WEP key.
Hardware Problem
Ethernet
The printer identified an Ether-
net error.
Turn the power off, and then
on. If the message appears
again, contact your sales or
service representative.
Hardware Problem
HDD
The printer identified a HDD
Board error.
Turn the power off, and then
on. Remove and re-install the
HDD board correctly. If the
message appears again, con-
tact your sales or service rep-
resentative.
See “Attaching Printer Hard
Disk Type 3000”, Setup
Guide.
Messages Description Recommended Action