Minolta 2210 Printer User Manual


 
Solving Other Problems72
Printing
takes too
much
time.
The printer is set to
a slow printing
mode (for example,
for OHP, thick
stock, or some
other special kind
of media).
It takes more time to print with special
media. When using regular paper, make
sure that the media type is set properly
in the driver.
The printer is set to
power saving
mode.
It takes a little time for printing to start in
power saving mode. If you do not want
to use this mode, disable it.
The printer mem-
ory is insufficient.
Add more memory.
A blank
startup
page
ejects or
blank
pages
come out
during a
printing
job.
One or more of the
toner cartridges is
defective, empty, or
missing.
Check the toner cartridges. The image
does not print if the cartridges are
empty.
If the toner cartridges are not empty
and blank pages are ejecting, take each
cartridge out, rock it from side to side,
and reinstall it in the printer.
The wrong media
is being used.
Check that the media type set in the
driver matches the media loaded in the
printer.
Not all
pages
print.
The printer could
have the wrong
kind of cable, or
your printer may
not be configured
for the correct
cable and port.
Check your cable.
The Cancel key
was pressed.
Make sure no one pressed the Cancel
key while your job was printing.
The media tray is
empty.
Check the message window to see if
the tray you are using is out of media.
Symptom Cause Solution
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500