Filter
Top Products
13 - 9
13. OPTIONS AND AUXILIARY EQUIPMENT
(2) Encoder cable
CAUTION
If you have fabricated the encoder cable, connect it correctly.
Otherwise, misoperation or explosion may occur.
POINT
The encoder cable is not oil resistant.
Refer to Section 12.4 for the flexing life of the encoder cable.
When the encoder cable is used, the sum of the resistance values of the
cable used for P5 and the cable used for LG should be within 2.4
.
When soldering the wire to the connector pin, insulate and protect the
connection portion using heat-shrinkable tubing.
When using the encoder cable of four-wire type communication system,
set "1
" in parameter No. 20 to select the four-wire type.
Generally use the encoder cable available as our options. If the required length is not found in the
options, fabricate the cable on the customer side.
When fabricating an encoder cable, use the recommended wires given in Section 13.2.1 and the MR-
ECNM connector set for encoder cable fabrication, and fabricate an encoder cable as shown in the
wiring diagram.
Refer to section 14.5 and choose the encode side connector according to the servo motor installation
environment.
(a) MR-EKCBL
M-L (standard flex life model)
These encoder cables are used with the HC-KFE series servo motors.
1) Model explanation
Standard flex life
Model: MR-EKCBL M-L
Symbol
Cable Length [m(ft)]
Communication System
2 (6.56)
5 (16.4)
10 (32.8)
20 (65.6)
30 (98.4)
Two-wire type
(Note) Four-wire type
Note: Set "1 " in parameter No. 20.
2
5
10
20
30
2) Connection diagram
For the pin assignment on the servo amplifier side, refer to Section 3.3.1.
1 23
456
789
MR MRR
MD MDR
P5E SHD
Encoder connecto
r
172161-9 (AMP)
CN2
30cm
(0.98ft)
Servo amplifier
Encoder connector
Encoder cable
supplied to servo motor
Servo motor
Encoder
Encoder cable
(option or fabricated)
50m(164.0ft) max.
CONT
P5G