Filter
Top Products
4. DS1 Facility Commands
4-10
August 2002 4200-A2-GB20-00
REPT-OPSTAT-T1
The REPT-OPSTAT-T1 command reports current operational parameters for T1
(DS1) lines.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* REPT-OPSTAT-T1:[tid]:aid_ds1:[ctag][:] */
;
Error Response
sid yy-mm-dd hh:mm:ss
M c DENY
/* REPT-OPSTAT-T1:[tid]:aid_ds1:[ctag][:] */
aid:ERRCDE=errcde
/* error description */
;
Table 4-8. REPT-OPSTAT- T1 Command Parameters
REPT-OPSTAT-T1:[tid]:aid_dsl:[ctag][;];
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_ds1 Access identifier for a a DS1 facility. The value can be preceded with
AID=, but this is not required. Enter in the following format, replacing
lower-case parameters with the values given:
NTT1-circuit
– circuit: DS1 circuit in the NT (1)
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.