Filter
Top Products
4. DS1 Facility Commands
4-2
August 2002 4200-A2-GB20-00
ED-T1
The ED-T1 Command edits configuration data associated with a DS1 facility.
Table 4-1. ED-T1 Command Parameters (1 of 2)
ED-T1:[tid]:aid_ds1:[ctag]:::[ds1_nblk]:[pst];
Restrictions: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_ds1 Access Identifier for a DS1 facility. The value can be preceded with
AID=, but this is not required. Enter in the following format, replacing
lower-case parameters with the values given:
NTT1-circuit
– circuit: DS1 circuit on the NT (1)
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
[ds1_nblk] Named parameter block for DS1. The block consists of one or more of
the following parameters, in any order separated by commas, each
followed by an equal sign and a valid value. If not specified, the values
of these parameters remain unchanged.
EQLZ: Line equalization (DSX1 interfaces only). See Table 4-4, T1 Line
Equalization Values.
LBO: Line build-out in dB (T1 interfaces only). Valid values are 0
(default), 7.5, 15, and 22.5.
LINETYPE: Type of line interface used. Valid values are:
– G703SHORT120: For E1 model. G.703 short-haul (≤655 feet)
interface (120 ohm connector).
– DSX1: For T1 model. T1 short-haul (≤655 feet) interface.
– G703LONG: For E1 model. G.703 long-haul (>655 feet) interface
(120 ohm connector). Default for E1 models.
– T1: T1 power loop. For T1 model. T1 long-haul (>655 feet)
interface. Default for T1 models.
– G703SHORT75: For E1 model. G.703 short-haul (≤655 feet)
interface (75 ohm connector).
TMG: Timing supply
– INT: Internal timing source. Use the NE system timing source.
– LPD: Loop timing (default)
PORTID: Port identifier (32 characters maximum). Indicates the user to
whom the port is assigned. The following values are reserved and
cannot be used:
– AVAILABLE: Port is not assigned.
– FAILED: Port has failed and cannot be assigned (default is null).