Filter
Top Products
10. Fault Commands
10-38
August 2002 4200-A2-GB20-00
RTRV-COND-T1
The RTRV-COND-T1 command retrieves current conditions of a DS1 facility.
Table 10-23. RTRV-COND-T1 Command Parameters
RTRV-COND-T1:[tid]:aid_ds1:[ctag]::[cond_ds1],[locn],[dirn]
;
RESTRICTIONS: All parameters in this command are position-defined.
[tid] The identification of the target NE. TID is optional and has a default
value of null. The NE's SID code is the only other valid value.
aid_ds1 Access Identifier for the environment. Valid value is:
NTT1-circuit
– circuit: DS1 circuit on the NT
[ctag] The correlation tag that correlates an input command with its associated
output response(s). It is assigned by the originator of the command. The
value is limited to six characters, which may be an identifier or a decimal
numeral. It is optional with a default of 0.
[cond_ds1] DS1 facility condition. Valid values are:
ACTLPBK: Facility placed in loopback
AIS: Alarm Indication Signal
LCD: Loss of ATM Cell Delineation
LOF: Loss of Framing
LOS: Loss of Signal/Clock
RAI: Remote Alarm Indication
If no value is specified, ALL is assumed. Grouping is allowed.
[locn] Location of the condition. Valid value is NEND (Near End).
[dirn] Direction of the signal. Valid value is:
RCV: Receive
If no value is specified, ALL is assumed.