Filter
Top Products
10. Fault Commands
10-28
August 2002 4200-A2-GB20-00
RTRV-COND-ADSL
The RTRV-COND-ADSL command retrieves the current condition of selected
ADSL line-related alarm indicators.
Table 10-17. RTRV-COND-ADSL Command Parameters
RTRV-COND-ADSL:[tid]:aid_adsl:[ctag]::[cond_adsl],[locn],[d
irn];
[tid] The identification of the target NE. TID is optional and has a default
value of null. The NE's SID code is the only other valid value.
aid_adsl Access identifier for the ADSL line(s). Enter in the following format,
replacing lower-case parameters with the values given:
ADSL-rack-shelf-slot-circuit
– rack: Rack Number (1)
– shelf: Shelf Number (1)
– slot: LT Slot Number (1)
– circuit: ADSL circuit on the LT (1− 24) (ranging allowed)
Grouping and ranging are allowed.
[ctag] The correlation tag that correlates an input command with its associated
output response(s). It is assigned by the originator of the command. The
value is limited to six characters, which may be an identifier or a decimal
numeral. It is optional with a default of 0.
[cond_adsl] ADSL condition. Valid values are:
NOPEER: No peer ATU present (Near End only)
FACTERM: Modem could not initialize (Near End only)
LCD-F: Loss of Cell Delineation (Fast)
LOS: Loss of Signal (Near End only)
LOF: Loss of frame
LOL: Loss of Link (Near End only)
LPR: Loss of Power (Far End only)
LORATE: Line rate is below planned rate (Loss of Signal Quality)
[locn] Facility location. Valid values are:
NEND: Near end
FEND: Far end
If no value is specified, ALL is assumed.
[dirn] Signal direction. Valid value is RCV Receive.