Filter
Top Products
2. Using the Command Line Interface
4200-A2-GB20-00 August 2002
2-7
Turn-up Procedure for Inband Management
Procedure
To turn up the GranDSLAM 4200 using inband management:
1.
Manual Mode:
At the unit, configure the IP address, net mask, and next-hop
router.
DHCP Mode:
Set the ATM1 physical address using the ED-IPPORT command
(see
ED-IPPORT
in Chapter 8,
IP Access Commands
), or accept the default,
which is based on the MAC address assigned to the unit.
Later, when determining what IP address has been assigned via DHCP, look
for the MAC address in the DHCP server table. The assigned address is
normally the address of the Ethernet port with the ATM physical address
appended (0101 for ATM-1 or 0202 for ATM-2). The RTRV-IPPORT command
retrieves IP port configuration information (see
RTRV-IPPORT
in Chapter 8,
IP
Access Commands
).
2. At the NOC, build a PVC through the network to the unit using VPI/VCI 0,32
and 1483 routed encapsulation. Then, configure routers, etc., as necessary to
route data from the NOC to the GranDSLAM 4200.
3. Enable security for your GranDSLAM 4200 unit. Using the TL1 command
ENT-USER-SECU, change the default login and password. Use the EMS to
configure SNMP community strings, the SYSLOG server, and trap managers.
4. Change the time, if necessary. The Simple Network Time Protocol (SNTP),
which maintains the unit’s clock, defaults to enabled for multicast. However,
you can change the time offset from Coordinated Universal Time (UTC) using
the TZOFFSET parameter of the SET-NE-ALL TL1 command. See
SET-NE-ALL
in Chapter 14,
System Commands
for more information.
Turn-up Procedure for Out-of-Band Management
In out-of-band management, you are managing the unit using the Ethernet
interface. This port is configured through the Console port.
Procedure
To turn up the GranDSLAM 4200 using the Ethernet interface:
1. At the unit, enable the Ethernet port.
2.
Manual Mode:
Assign an IP address, netmask, and next-hop router.
DHCP Mode:
Configure the DHCP server out of the Ethernet port.
3. Configure routers, etc., as necessary to route data from the NOC to the
GranDSLAM 4200.
4. Reset the DHCP server and the SNTP since they default to managing from the
ATM interface (inband management).