Filter
Top Products
10. Fault Commands
4200-A2-GB20-00 August 2002
10-25
RTRV-ATTR-T1
The RTRV-ATTR-T1 command retrieves current attributes of activities related to
the DS1 facility.
Table 10-15. RTRV-ATTR-T1 Command Parameters
RTRV-ATTR-T1:[tid]:[aidall_t1]:[ctag]::[ntfcde],[cond_ds1],
[locn],[dirn];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] The identification of the target NE. TID is optional and has a default
value of null. The NE's SID code is the only other valid value.
[aidall_t1] Access Identifier for all T1 (DS1) facilities. The value is T1.
[ctag] The correlation tag that correlates an input command with its associated
output response(s). It is assigned by the originator of the command. The
value is limited to six characters, which may be an identifier or a decimal
numeral. It is optional with a default of 0.
[ntfncde] Notification code. Valid values are:
CR: Critical alarm
MJ: Major alarm
MN: Minor alarm
NA: Not alarmed (reported via REPORT EVENT)
Grouping is allowed. If no value is specified, ALL is assumed.
[cond_ds1] DS1 facility condition. Valid values are:
ACTLPBK: Facility placed in loopback (Default = NA)
AIS: Alarm Indication Signal
LCD: Loss of ATM Cell Delineation
LOF: Loss of Framing (Default = MN)
LOS: Loss of Signal/Clock (Default = MI)
RAI: Remote Alarm Indication (Default = MN)
If no value is specified, ALL is assumed.
[locn] Location of the condition. Valid value is NEND (Near End).
Only applicable to conditions supporting location.
[dirn] Direction of the signal. Valid value is:
RCV: Receive
If no value is specified, ALL is assumed.