Filter
Top Products
3. ADSL Facility Commands
4200-A2-GB20-00 August 2002
3-21
ED-PROFILE-ADSLUPALM
The ED-PROFILE-ADSLUPALM command enables you to edit ADSL alarm line
configuration parameters for the upstream direction (from ATU-R to ATU-C) in an
ADSL Alarm Profile. See
ENT-PROFILE-ADSLALM
on page 3-26 for information
on how to create a new ADSL alarm profile.
Table 3-17. ED-PROFILE-ADSLUPALM Command Parameters (1 of 2)
ED-PROFILE-ADSLUPALM:[tid]:adsl_profile_id:[ctag]:::[adslpr
of_nblk];
RESTRICTIONS: All parameters in this command are position-defined. After a profile is
activated, its parameters cannot be edited.
[tid] Identification of the target NE. TID is optional and has a default value of
null. The NE's SID code is the only other valid value.
adsl_profile_id Numeric identifier of a profile (1−30).
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
[adslprof_nblk] ADSL parameter block containing one or more of the following named
parameters (separated by commas):
LOFS-L: Loss Of Frame Seconds (line). SNMP trap and TL1
autonomous message are sent if the number of LOFS events in a
15-minute interval meets or exceeds the selected value (0−900
seconds, where 0 disables the messages). The default is 0.
LOSS-L: Loss Of Signal Seconds (line). SNMP trap and TL1
autonomous message are sent if the number of LOSS events in a
15-minute interval meets or exceeds the selected value (0−900
seconds, where 0 disables the messages). The default is 0.
LOLS-L: Loss Of Link Seconds (line). SNMP trap and TL1 autonomous
message are sent if the number of LOLS events in a 15-minute interval
meets or exceeds the selected value (0−900 seconds, where 0 disables
the messages). The default is 0.
ES-L: Errored Seconds (line). SNMP trap and TL1 autonomous
message are sent if the number of ES events in a 15-minute interval
meets or exceeds the selected value (0−900 seconds, where 0 disables
the messages). The default is 0.
SES-L: Severely Errored Seconds (line). SNMP trap and TL1
autonomous message are sent if the number of SES events in a
15-minute interval meets or exceeds the selected value (0−900
seconds, where 0 disables the messages). The default is 0.
UAS-L: Unavailable Seconds (line). SNMP trap and TL1 autonomous
message are sent if the number of UAS events in a 15-minute interval
meets or exceeds the selected value (0−900 seconds, where 0 disables
the messages). The default is 0.
INCRATE-F: Increasing Rate (fast channel). SNMP rate change trap
and TL1 autonomous message are sent if the current rate is ≥ the
previous rate plus this threshold (0-2176 kbps in 32 kbps increments,
where 0 disables the messages). The default is 0.