Filter
Top Products
14. System Commands
4200-A2-GB20-00 August 2002
14-31
SET-NE-ALL
The SET-NE-ALL command sets common configuration parameters associated
with the NE.
Table 14-25. SET-NE-ALL Command Parameters (1 of 2)
SET-NE-ALL:[tid]:[aid_com]:[ctag]:::ne_nblk;
RESTRICTION: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
[aid_com] Access Identifier for all common equipment. The value can be preceded
with AID=, but this is not required. The value is COM.
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
ne_nblk Named parameter block for NE. The block consists of one or more of
the following parameters, each followed by an equal sign and a value. If
not specified, the values of these parameters remain unchanged.
BOOTPVCI : ATM VCI of the PVC over which the NE issues BOOTP
requests (32−1023) for ATM-1. The default value is 32.
BOOTPVPI: ATM VPI of the PVC over which the NE issues BOOTP
requests (0−15) for ATM-1. The default value is 0.
MEMALM: Used to clear alarm condition indicating loss or corruption of
persistent memory. The only valid value is CLEAR.
MEMDNLD: Determines whether an external download is persistent in
the database (typically used to restore the database from the previous
backup version). The only valid value is ENABLED.
DEFROUTER: IP address of default IP router. Values are:
– ddd.ddd.ddd.ddd: IP address (ddd = 1−255)
– NONE: No default IP router is used (default)
NETPOS: Position of the NE in the access subnetwork. Value is HUB
(NE is directly connected to the network).
SNTP: Use of Simple Network Time Protocol to maintain NE clock.
Values are:
– ENABLED: Use SNTP
– DISABLED: Use NE local time set by the command SET-DAT on
page 14-29.
TZOFFSET: Offset of local time zone from GMT/UTC, in minutes
(-780−780). The default is 0 minutes. Used by the system if SNTP is
enabled.
SNTPMODE: The SNTP mode. Valid values are:
– MULTI: Multicast (default)
– BROAD: Broadcast
– UNI: Unicast (to server at SNTPIPADDR)