Paradyne 4200 Network Card User Manual


 
8. IP Access Commands
8-6
August 2002 4200-A2-GB20-00
ED-IPPORT
The command ED-IPPORT edits configuration data associated with an Internet
Protocol port (or interface) in the NE.
Table 8-5. ED-IPPORT Command Parameters (1 of 2)
ED-IPPORT:[tid]:aid_ipport:[ctag]::cfg_mode:ipport_nblk
[pst];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_ipport Access identifier of the IP port to be entered. The value can be
preceded with AID=, but this is not required. The valid values are:
ATM-1: First IP-over-ATM interface in the NT
ATM-2: Second IP-over-ATM interface in the NT
ETH-1: First Ethernet interface in the NT
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
cfg_mode Configuration mode for the IP port. Valid values are:
MANUAL: Port parameters are configured by the operator.
BOOTP: Port parameters are configured using the BOOTP protocol.
ipport_nblk Named parameter block for IP Port. The block consists of one or more
of the following parameters, in any order separated by commas, each
followed by an equal sign and a valid value.
IPADDR: IP address associated with the port. Required if
cfg_mode=MANUAL. Auto-configured if cfg_mode=BOOTP. Valid
values are:
ddd.ddd.ddd.ddd (where ddd is a number 1255).
NETMASK: IP address network mask. Required if cfg_mode=MANUAL.
Auto-configured if cfg_mode=BOOTP. Valid values are:
ddd.ddd.ddd.ddd (where ddd is a number 1255). All values are
valid for ETH-1. For ATM-1 and ATM-2, the value must be
255.255.255.255.
GATEWAY: IP address of the default IP router (gateway) for this IP
interface. Valid values are:
ddd.ddd.ddd.ddd (where ddd is a number 1255) for ETH-1 only.
NONE: No gateway
PHYADDR: Physical address associated with the port. Used by BOOTP
on ETH-1. Valid values are:
xx-xx-xx-xx-xx-xx-xx-xx where each x is a hexadecimal digit
(0F). This must be the MAC address originally assigned to the
unit if aid_port is ETH-1.