Filter
Top Products
C. Traps and MIBs
4200-A2-GB20-00 August 2002
C-17
Virtual Channel Cross Connect Group (RFC 2515)
This table contains configuration and state information of point-to-point,
point-to-multipoint, and multipoint-to-multipoint VC cross-connections for PVCs.
This table has read access and is used to cross-connect the VCLs together in an
ATM switch or network that belongs to a VC connection (see Ta ble C-8, V ir tual
Channel Cross Connect Group Objects).
Table C-8. Virtual Channel Cross Connect Group Objects
Object Description Setting/Contents
atmVcCrossConnectL2HOper
Status
(atmVcCrossConnectEntry 9)
Identifies the current operational status
of the VC cross-connection in one
direction (low to high).
The only valid values are:
up(1)
down(2)
unknown(3): Not supported.
atmVcCrossConnectH2LOper
Status
(atmVcCrossConnectEntry
10)
Identifies the current operational status
of the VC cross-connection in one
direction (high to low).
The only valid values are:
up(1)
down(2)
unknown(3): Not supported.
atmVcCrossConnectL2HLast
Change
(atmVcCrossConnectEntry
11)
Identifies the value of the Mib II’s
sysUpTime object at the time that this
VC cross-connection entered its current
operational state in a low to high
direction.
Integer. If the current state was entered
into prior to the last reinitialization of the
agent, then this object contains a zero
value.
atmVcCrossConnectH2LLast
Change
(atmVcCrossConnectEntry
12)
Identifies the value of the Mib II’s
sysUpTime object at the time that this
VC cross-connection enterde its current
operational state in a high to low
direction.
Integer. If the current state was entered
into prior to the last reinitialization of the
agent, then this object contains a zero
value.
atmVcCrossConnectRowStat
us (atmVcCrossConnectEntry
13)
Used to create a new cross-connection
row for the cross-connecting VCLs
created using the atmVclTable or to
change or delete an existing
cross-connection.
The only valid values are:
active: Cannot be set to active unless
the atmVcCrossConnectAdminStatus
object exists in the row.
createAndGo
destroy