Filter
Top Products
9. Performance Commands
9-8
August 2002 4200-A2-GB20-00
Table 9-6. REPT-OPSTAT-ADSLUP Response Parameters
Parameter Explanation
tid Target NE identification
yy-mm-dd Year, month, and day
hh:mm:ss Hour, minute, and second
M Message generated in response to an input command
c If provided, ctag; otherwise 0
COMPLD Completed
DENY Input command is denied
/* */ Enclosed are human readable comments – unspecified format
errcde Error code (see Appendix A,
Error Codes
)
aid_adsl As described for command parameters (see Ta bl e 9 -5,
REPT-OPSTAT-ADSLUP Command Parameters).
op_adsl ADSL operational parameter. Values are:
ATEN: Signal attenuation (0 − 60 dB)
CELLSF: Rolling count of cells transmitted upstream on Fast channel
(received by ATU-C)
CELLSDSCF: Rolling count of cells received on Fast channel and
discarded for any reason
CURFBR: Current Fast channel bit rate (32 − 2176 QOSCLASSF:
Quality of Service for the ADSL Fast channel. The supported option is
UBR (Unspecified bit rate). UBR is the default.
EWL: Equivalent Working Length. Specifies the length of the DSL line.
This value is used to limit transmit rates and maximum power settings
according to local spectrum management guidelines. EWL is usually
specified by the carrier. The default is 10 kft. The values supported are:
– 8.5 to 14.5 kft in .5 kft increments
– >14.5 kft
POTSLVL: POTS Level. Specifies the voltage used to detect the
presence of Plain Old Telephone Service (POTS) on the DSL line. The
dafault is 3 volts. The values supported are:
– 0 to 74 volts, in 1-volt increments (setting to 74 volts disables
POTS detection)
– Disable (disables POTS detection)
NMR: Noise margin (0 − 31 dB)
PWR: Transmitted signal power n (0−20 dB)
RELCAP: Relative capacity operation. Configured bit rate as a
percentage of the cuurent bit rate (0 − 100)
UNKCELLSF: Rolling count of received cells discarded during cell
header validation with unrecognized VPI/VCI values
value Value of parameter specified by op_adsl