Filter
Top Products
15. Test Commands
4200-A2-GB20-00 August 2002
15-7
RLS-LPBK-T1
The RLS-LPBK-T1 command releases any loopback currently active at the near
end of a specific T1 facility, including configured loopbacks (set with the command
OPR-LPBK-T1
on page 15-2) and inband loopbacks (set with DS1 inband
loopback codes).
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/* RLS-LPBK-T1:[tid]:aid_ds1:[ctag][:] */
;
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY
/* RLS-LPBK-T1:[tid]:aid_ds1:[ctag][:] */
aid:ERRCDE=errcde
/* error description */
;
Table 15-5. RLS-LPBK-T1 Command Parameters
RLS-LPBK-T1:[tid]:aid_ds1:[ctag][:];
RESTRICTIONS:
All parameters in this command are position-defined.
Port loopbacks are supported only on LT ports.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_ds1 Access Identifier for the T1 facility. The value can be preceded with
AID=, but this is not required. Enter in the following format, replacing
lower-case parameters with the values given:
NTT1-circuit
– circuit: DS1 circuit on the NT (1)
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.