Filter
Top Products
8. IP Access Commands
4200-A2-GB20-00 August 2002
8-9
ENT-ATMARPENT
The command ENT-ATMARPENT defines a new entry in the ATM Address
Resolution Protocol table in the NE.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
IP c
After the above response, a new command input may be generated.
Normal Response:
sid yy-mm-dd hh:mm:ss
M c COMPLD
/*
ENT-ATMARPENT:[tid]:aid_ipport:[ctag]::ip_addr,[vpi][vci] */
;
Table 8-7. ENT-ATMARPENT Command Parameters
ENT-ATMARPENT:[tid]:aid_ipport:[ctag];;ip_addr,[vpi],[vci]
[arpent_nblk];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_ipport Access identifier of the IP port to be deleted. The value can be
preceded with AID=, but this is not required. The valid values are:
ATM-1: First IP-over-ATM interface in the NT
ATM-2: Second IP-over-ATM interface in the NT
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
ip_addr The next-hop IP address associated with the port. Valid values are:
ddd.ddd.ddd.ddd (where ddd is 1−255).
[vpi] The ATM Virtual Path Identifier (0−15) associated with the virtual circuit
for the entry. If no value is specified, BOOTVPI is used on ATM-1.
Required for ATM-2. See SET-NE-ALL on page 14-31 for more
information.
[vci] The ATM Virtual Channel Identifier (32−1023) associated with the
virtual circuit for the entry. If no value is specified, BOOTVCI is used on
ATM-1. Required for ATM-2. See SET-NE-ALL on page 14-31 for more
information.
[arpent_nblk] The named parameter block for the ARP table. The block consists of
the following parameter followed by an equal sign (=) and a valid value:
BITRATE: Bandwidth associated with the ATM VC for the entry. The
valid value is 0 (UBR).