Filter
Top Products
RuggedRouter® User Guide
TC Classes
This menu allows you to add, edit, or remove a traffic classification class. Please note
that each class is associated with exactly one network interface. Exactly one class for
each interface must be designated as default. Unmarked traffic (packets which have
not been assigned a mark value in the TC Rules menu or via VLAN 802.1p) will be
handled by the default class. Classes can match packets either by their assigned mark
or by their ToS field. The ToS field takes precedence over the mark.
Add a new traffic class by selecting the Add a new traffic classification class link or
by clicking on the add-above or add-below images in the Add column.
Clicking on a link in the Interface column will allow you to edit or delete a traffic
classification class as shown below. The Manually Edit File button also allows you
to make direct changes to the TC Classes configuration file.
The Interface field specifies which network interface this TC Class applies to.
The Mark to match field specifies what mark value this TC Class will match. The
mark may be in the range 1..255 in decimal or hex.
The Minimum rate field specifies the minimum bandwidth allocated to this class.
The Maximum rate field specifies the maximum bandwidth allocated to this class.
132 RuggedCom
Figure 115: TC Classes
Figure 116: Edit TC Classes