RuggedCom RX1000 Network Router User Manual


 
Chapter 29 - Maintaining The Router
Snmpd will use these addresses providing they are active at the time it starts. By
default, snmpd listens on all interfaces.
Access Control
The first part of the Access control page allows the creation and deletion of SNMP V1
and V2c community names.
The Community Name field selects the name of the community. The Access field
determines whether the community is read-only or read/write. The Source IP field
may be used to specify an IP address or range (e.g. 10.0.0.0/24) from which access to
this community name may be made. The OID field further restricts access to an
Object Identifier (OID) tree at or below a specified OID.
The second part of the Access control menu allows creation and deletion of V3 users.
The User Name field selects the name of the new user.
The Access field determines whether the community is read-only or read/write.
RuggedCom 273
Figure 248: Access Control Menu, SNMP V1 and V2c
Figure 249: Access Control Menu, SNMP V3