Filter
Top Products
Chapter 27 - Configuring IRIGB And IEEE1588
IRIGB Configuration
Figure 210: IRIGB Configuration menu
This menu allow you to configure IRIGB parameters. The save button will save the
changes of configuration permanently.
The AM Port 1 (PTP1) Output field enables or disables the amplitude modulated
output of this port.
The TTL Port 2 (PTP2) Output and TTL Port 3 (PTP3) Output fields sets the
output formats of these ports to PPS, PWM and OFF.
IEEE1588 Configuration
Figure 211: IEEE1588 Configuration Menu
This menu allows you to configure IEEE 1588 parameters.
The 1588 Working Mode field allows configures whether the router will be forced to
1588 slave mode or determine its role by the BMC algorithm.
The Preferred Master Clock field configures the router to be preferred master clock.
The Subdomain Name field allows you to choose which domain you want the router
to participate in. There are four domains available, each mapped to a different
multicast IP address.
The Sync Interval field configures the rate at which SYNC messages are issued.
The router NTP daemon uses GPS as a clock source when it is available and with
IEE1588 when GPS is not available.
The Treat NTP sync'd grandmaster as stratum field assigns the stratum number
when grandmaster clock synchronized with remote NTP server but not GPS.
The Treat Local Clock sync'd grandmaster as stratum field assigns the stratum
number when grandmaster clock synchronized with local clock but not NTP server or
GPS.
RuggedCom 245